The PRO SERIES reflectors were engineered to create the perfect beam spread for sports lighting. Pro Series offers multiple configurations ranging from a narrow to wide beams to fit any application.
- Factory wired, pre-aimed and pre-assembled.
- Maintenance diagnostic system.
- Remote ballast assembly, fully supported with aluminum “C” back channel.
- Ballast enclosure is powder coated galvanized sheet steel with sealed door. Protects electrical components from dirt, moisture and insects.
- Wiring harness for ballast to cross-arm assembly connection.
- UL Listed two ballast per enclosure reducing operating temperatures.
- Large reflector, uniquely designed for aerial sports, with 45 degree lamp position to efficiently control light output.
- Six 1″ clips, secure lens ring and evenly seats gasket to the rolled edge of the reflector.
- Rugged, anodized cast aluminum mogul housings and arms. Vertical re-positioning aiming pin assures re-aiming after scheduled maintenance.
- Steel cross-arms and hardware galvanized after fabrication, adaptable to any pole requirement.
- Wind tunnel tested up to 130 mph with a 1.3 gust factor.
- Stainless steel fittings are aqua-poxy coated for dual corrosion protection.